Tell us about the key
Read out the brand and any numbers on the key head, or send a photo. That tells us the profile, and whether it is a blank we can cut.
Key cutting in Vancouver, done where you are: we bring the key machine to your home, suite or office. There is no shop counter to visit. Call 604-227-9083 and your copies are cut and tested on site.
The machine and the blanks come to you, and every copy is tried in your lock before we leave.
We do key cutting in Vancouver at your door, not over a counter. Fast Locksmith Vancouver is mobile only, with no storefront and no walk-in hours.
You call, a technician brings the cutting machine, and your original never leaves your hand.
Some pre-war front doors on the west side still take a long bit key. A bit key can't go through a duplicator. It is filed by hand to fit the wards inside that one lock.
That is slower work, priced as a key cut from the lock. It is still cheaper than replacing a sound old lock body, which matters in older homes such as those in Shaughnessy.
Read us what is stamped on the key head and tell us how many copies you need. The total for your address is confirmed on the call before a technician is sent.
Dimple and restricted keys cost more because the blanks are controlled and the cuts are finer.
Every range we publish is on our locksmith prices page.
See locksmith prices →Read out the brand and any numbers on the key head, or send a photo. That tells us the profile, and whether it is a blank we can cut.
A technician brings the machine to your home, office or building. Technician availability and arrival are confirmed on the call.
Each copy is cut to your original and turned in the lock with the door open, then closed. A copy that drags is recut before we pack up.
A restricted key is cut on a blank that is not sold openly. The system has a registered holder, and only that holder can approve another copy.
For a home, the holder is usually you, with ID and any card or paperwork that came with the lock. For a business or building, it is the owner, manager or strata.
Some patented blanks are only supplied through the system's authorized dealer. If yours is one of them, we tell you on the call. New cylinders are covered under high-security locks.
In a strata building, your suite door is yours and the shared parts belong to the strata.
Extra fobs and common-area keys come from them, not from a locksmith.
In some towers the suite key also opens the lobby or the garbage room. If it does, it is part of the building's keying, and copies go through the strata. It comes up often in high-rise strata in the West End.
A copy is only as good as the key it was cut from.
If your original is worn, we can often read the lock and cut to its proper depths instead of copying the wear.
An old cylinder in a rental walk-up may have seen many tenancies, and nothing turns cleanly, the owner's key included. A sharper copy won't fix it, and we will say so rather than sell you three. The fix is a rekey or lock change, often at the same visit.
If the key turns but the bolt won't reach the strike, the door has moved. That is a job for door repair, not a new key.
Most car keys carry a chip that has to be programmed to the vehicle. A blade from our key machine might open the door, yet the engine still won't start.
That work is on our car key replacement page. We check ID and proof of ownership before cutting or programming any car key.
No. We are mobile only, with no storefront or counter. A technician brings the key machine to your home, office or building and cuts your copies there.
A standard house or suite key is $5 – $15 per copy. Mailbox, padlock and cabinet keys are $8 – $20. The total for your address is confirmed on the call.
Often, yes. We read the lock or cut by code, which runs $40 – $90. It takes longer than a copy, but it can save replacing a lock that still works.
No. Fobs and lobby, parkade and common-area keys belong to your strata or property manager, so ask them for extras. We copy your own suite, house and padlock keys.
Mobile key cutting across the city of Vancouver and the UBC area.
Each area page covers the doors, buildings and locks we see in that part of the city.
View Service Areas ↗Tell us which keys you need copied and where you are. Your copies are cut and tested at your door, and arrival is confirmed on the call.
Pick-, drill- and bump-resistant cylinders with keys that can’t be copied at the hardware store. Cut, pinned and registered in-shop.
1/2" steel door, digital keypad, fitted and bolted on site.
Car keys are priced by vehicle. Pick what you need and we’ll collect your make, model & year to text you an exact quote.